Kennelseal is a clear, solvent-based epoxy resin sealer, which can be used to waterproof all porous surfaces. The hydrophilic properties of Kennelseal enable it to locate and displace water from the pores of the substrate where it then cures to form a permanently sealed surface layer.

As well as waterproofing it also seals against bacteria and viruses; and prevents algae growth. Kennelseal will protect concrete from acid attack from urine and other animal wastes. Kennelseal will seal softwoods to prevent bacterial colonisation and retention of parasite eggs and fungal spores, e.g. ringworm and E-Coli.

Castle Seal will also prevent the transmission of damp through walls and floors of buildings. It can be used inside and out.

+ = Resistant 0 = Not resistant All chemical resistance is measured at 21⁰C

Kennelseal can be applied by low pressure spray, roller or brush. One coat will normally be sufficient to seal most porous surfaces and leave the surface virtually unchanged in appearance. Second and subsequent coats will leave a slight surface sheen. All surfaces to which Kennelseal is to be applied should ideally be clean, dry and free from dust and loose particles. Acceptable penetration and adhesion can be achieved on damp surfaces (remove surface water first). Mix two parts of Kennelseal Base with one part of Hardener and stir well for 2/3 minutes. (7.5 litre packs are pre-measured). Mixed material will remain usable for 24 hours if the container is kept sealed.

Application with a low pressure sprayer is most economical but rollers and brushes are equally effective (if spraying, use a sprayer suitable for solvents otherwise the internal seals may be affected by solvent). The Castleseal ''Sure Shot'' sprayer is recommended.

After application, allow the first coat to soak in. Water droplets may appear on the surface as the product penetrates and drives out the moisture. Allow the first coat to cure for at least 2 hours before overcoating.

One or two coats of Kennelseal are an effective waterproof barrier however Kennelseal may also be over painted with any conventional paint systems. It may also be plastered or rendered over with conventional screeding materials.

WARNING: Kennelseal contains volatile, highly flammable solvents. It must only be applied outside or in a well-ventilated area otherwise breathing apparatus and extraction equipment will be required. Observe Health and Safety information on labels.

Dry film thickness 17 microns

Coverage 15-18 m²/litre (1 coat)

Kennelseal as a masonry damp proofing: one coat normally sufficient.

Kennelseal as protection against staining on concrete etc.: one coat normally sufficient, two coats will produce a slight sheen.

This data is provided in good faith for guidance purposes however due to variations in equipment and local conditions. Users should carry out their own tests to ensure that satisfactory results can be obtained.